* At the terminal, press enter a couple of seconds after boot to prevent it from booting using the onboard flash (Ubuntu). You should end up with a ''Marvell>>'' prompt.

* There are some commands you need to run to make it permanently boot from the USB port ('''NOTE:''' this step is only necessary once):

setenv arcNumber 2097

setenv bootargs_root 'root=/dev/sda1 rootdelay=15'

setenv bootcmd 'setenv bootargs $(console) $(bootargs_root); run bootcmd_usb; bootm 0x6400000'

saveenv

* In order to install the rootfs onto a flash or disk, mount the flash drive on a linux system and execute the [http://dl.amahi.org/marvell/create-clean-f12-disk.sh create-clean-f12-disk.sh] script. You'll need to have the [http://dl.amahi.org/marvell/amahi-marvell-0.5.tar.bz2 amahi-marvell-0.5.tar.bz2] file in the current directory. It may take a while, but this must be done before booting up the plug and installing Amahi.