Transition to Amahi

Probably one of the most difficult part of transitioning to using your Amahi HDA with the full recommended experience is to get all systems to use your HDA for DNS.

A typical symptom is that either accessing the dashboard as

http://hda

or apps that have a web interface (or both) are not reachable and leads to some site on the internet (like amahi.net).

For best results, we recommend that you fully transition your network to using your Amahi server at least for DNS.

The easiest and simplest way to do this is to do these things in the following order:

1. turn off any other DHCP server in your network, typically in your router/gateway
2. restart the networking (or the whole device) in your client device. Turn off WiFi and turn it on if it has WiFi, or simply reboot

If you have any fixed IP devices in your network from your router settings, you can also set them in your HDA under Setup > Networking > Fixed IPs.

An Alternative

Alternatively, if you cannot or do not want to turn off your router DHCP, you can still use the DNS server in your HDA.

To do this, since the the DNS settings for the DHCP server in your router and fill them (both primary server and secondary) to be the IP of your HDA.

You should set them both to the IP of the HDA, so that the HDA is your DNS server for all your devices, which still need to be rebooted to pick these new settings up.

This way, your clients will still use your router for DHCP, but DNS from your Amahi HDA, hence accessing the apps via the short URLs will work.

The last step is to stop the DHCP server in your HDA under Setup > Networking > Settings. For this menu to show, you have to turn on Advanced settings under Setup > Settings.

If you have further networking trouble, consult the Network Troubleshooting page.