Difference between revisions of "Post-Install Hardware Changes"
| Line 5: | Line 5: | ||
<!--At the top of the page can be visible one of the following tags..--> | <!--At the top of the page can be visible one of the following tags..--> | ||
{{WorkInProgress}} | {{WorkInProgress}} | ||
| + | <i>This article belongs in the "Getting Under the Hood" section</i> | ||
{{NeedsMerge | [[Main Page]]}} | {{NeedsMerge | [[Main Page]]}} | ||
<!--{{NeedsExpantion}}--> | <!--{{NeedsExpantion}}--> | ||
Revision as of 02:52, 25 June 2012
|
Work In Progress |
|---|---|
| This article is currently undergoing major expansion or restructuring. You are welcome to assist by editing it as well. If this article has not been edited in several days, please remove this template. |
This article belongs in the "Getting Under the Hood" section
|
Merge |
|---|---|
| It has been suggested that this page or section be merged with Main Page |
Post-Install Hardware Changes
Preliminary: Swapping hardware in a Linux system such as Amahi/Fedora is very forgiving and simple for the most part. Amahi does depend, however, on having the eth0 network interface and your shares depend on having the right drives and SATA ports identified between hardware changes to avoid lengthly repair processes.
If swapping:
>> Motherboard/ SATA-controller/ RAID-card <<
- you have no changes to make when booting back into Fedora, which will just re-fit drivers to the new part.
- It is advisable though, to reconnect your drives in the same sequence they were before the swap of the motherboard/ sata-controller/ RAID-card..
eg:
before the part-swap
sata port 01 = sata drive sda
after the part-swap
sata port 01 = sata drive sda
..and so on.
- In the BIOS/ UEFI, ensure that the boot sequence is also the same.
If swapping:
>> network card <<
- you must ensure that the same ethernet device assignment stands as before the part swap.
- If anything eth0 may become eth1 afterwards, so you will need to rename it to eth0 via the Network Manager in the Fedora desktop. You'll want to reboot to finalize changes. (((command-line process coming soon)))
If swapping:
>> CPU / RAM / video card <<
- no changes need to be done after boot. These drivers should automatically load on a reboot of Fedora.
