Difference between revisions of "Ubuntu Installation Troubleshooting"
From Amahi Wiki
(Created page with "= Troubleshooting = Double check your network settings with '''<code>ifconfig</code>''' and '''<code>route -n</code>'''. These should be the settings that you use in the install...") |
|||
| Line 1: | Line 1: | ||
| − | = | + | = Loss of Network Connectivity = |
| − | |||
Double check your network settings with '''<code>ifconfig</code>''' and '''<code>route -n</code>'''. These should be the settings that you use in the installation. If these are not correct you can change the ip address by issuing the command | Double check your network settings with '''<code>ifconfig</code>''' and '''<code>route -n</code>'''. These should be the settings that you use in the installation. If these are not correct you can change the ip address by issuing the command | ||
{{Code|sudo ifconfig eth0 192.168.1.14 netmask 255.255.255.0 up}} | {{Code|sudo ifconfig eth0 192.168.1.14 netmask 255.255.255.0 up}} | ||
Revision as of 00:23, 6 July 2012
Loss of Network Connectivity
Double check your network settings with ifconfig and route -n. These should be the settings that you use in the installation. If these are not correct you can change the ip address by issuing the command
| bash code |
|---|
sudo ifconfig eth0 192.168.1.14 netmask 255.255.255.0 up
|
assuming 192.168.1.14 is your IP address. The route can be changed with
| bash code |
|---|
sudo route add default gw 192.168.1.1
|
assuming 192.168.1.1 is the address of your router.
This is especially important if you are doing a headless install
