#REDIRECT [[Amahi_Plug_Edition]]
'''Note: Most of this information is duplicated elsewhere. It needs to be verified and removed as necessary.'''
See [[Amahi_Plug_Edition | Amahi_Plug_Edition]] for installation and supported devices.
= Misc Notes =
* restarting rpm db in chrooted environment:
{{Code|rm /var/lib/rpm/__db*
rpm --rebuilddb -vv}}
<!--* May need to add the following line to /etc/resolv.conf if you have DNS issues:
nameserver 8.8.8.8-->
<!-- OLD NOTES
* 2 stop bits to get the bootloader to recognize keyboard and stop autobooting
* speed: 115200 /dev/ttyUSB1
* rpms installed for amahi: httpd, ruby, samba,
* build hdactl, hda-platform, install (with --nodeps)
Missing deps in the installer:
* httpd, samba, cadaver, bind-utils
RPMs not available from the mirrors:
* hda-greyhole
* cadaver
* rubygem-gd2 - actually - is this one necessary?
* ruby-RMagick
* ssh into the plug
* yum -y install httpd
* Install the hda-release
** <small><code>rpm -Uvh <latest_rpm repo="amahi-f12" rpm="hda-release" arch="noarch" output="url" /></code></small>
* Install hdactl
** <small><code>rpm -Uvh --nodeps <latest_rpm repo="amahi-f12" rpm="hdactl" arch="armv5tel" output="url" /></code></small>
* Now install <code>hda-platform</code>
** <small><code>rpm -Uvh --nodeps <latest_rpm repo="amahi-f12" rpm="hda-platform" arch="noarch" output="url" /></code></small>
* Install dependencies:
** <small><code>yum -y install rubygems ruby-libs ruby-mysql</code></small>
* Start the Amahi installer.
** <small><code>service amahi-installer start</code></small>
Other:* VPN does And last but not work (turned off in servers)least, get the installer going by accessing it with a browser: Cannot allocate TUN/TAP dev dynamically* Greyhole not working - hda-greyhole needed* crontab does not appear to be working* had to add with noatime in <code><nowiki>http:/ to prevent flash burnout* should control monit - it keeps on pounding the flash with messages in /varyour_ip_address:2000</lognowiki></monit* would like to add swap to flash based drives* mt-daapd and amahi-transmission are dyingcode>
= Getting it Going =Here are the steps to make it boot from USB* Connect input the JTAG module install code and connect the USB side to a terminal emulator* Putty for windows (Serial)* gtkterm for linux (use 2 stop bitsinstall!)* Reset the device from the JTAG module* At the terminal, press enter a couple of seconds after boot to prevent NOTE: it booting may be better to the flash* There are some commands to make it permanently boot off USB:report bugs!-->