Trusted, Bureaucrats, Administrators
12,424
edits
Changes
From Amahi Wiki
no edit summary
saveenv
reset
* In order to install the rootfs onto a flash or disk, mount the flash drive on a linux system and execute the create-clean-f12-disk.sh script. It may take a while, but this must be done before booting up the plug and installing Amahi.
'''NOTE:''' This script is very dangerous (it can destroy the machine it is run on if not used properly). You will need to change the partition destination.
* Insert USB Flash Drive into the plug.
* Once this is complete, the JTAG module can be disconnected. There will be no need for serial connection any longer. Once the USB Flash Drive is connected and the plug booted, you will be able to connect via SSH.
= Amahi Install =
* Configure a profile for the system in http://www.amahi.org. Pay attention to the IP of the HDA you configure. Let's call it PLUG_FIXED_IP.
* Boot the system with the latest rootfs (amahi-marvell-0.2.tar.bz2).
* Until we optimize things, it will take 4 or 5 minutes to boot the first time.
