Changes

From Amahi Wiki
Jump to: navigation, search
717 bytes added ,  22:37, 14 September 2015
no edit summary
{{NeedsUpdate}}
 
 
Installing Amahi with RAID 1 in 2HDD setup. See this other page for [[RAID5]].
If you perform either of these setups and have trouble with one of the members of the RAID1 array not joining on reboot, try this possible solution. [[#Losing drive on reboot]]
 
________________________________________________________________________
So, to set the scene. I'm pretty much totally new to Linux and I'm just an enthusiastic amateur when it comes to computers in general.
=<span id="reboot_fix">Losing drive on reboot</span>=
 
If you perform either of the above setups and find that on reboot one member of the array is not present and the command "mdadm --detail /dev/md0" shows that the array is degraded, the following may help.
 
In a Fedora forum thread - http://www.fedoraforum.org/forum/showthread.php?t=255048 it was found that some makes of hard drives can cause this problem as they take a while to spin up so the system ignores one of them and carries on with the degraded array.
 
To fix this, apply the recommended lines to your /etc/rc.d/rc.local file. Make sure you backup the file before doing this just in case and do this all as root.
12,424

edits