Amahi 7 full DVD
From Amahi Wiki
(Redirected from Amahi 7 32bits)
|
WARNING |
|---|---|
| Amahi 7 for Fedora 19 Maintenance Support ONLY! Please use a supported release! |
Steps for installing Amahi 7 from the full DVD:
Prerequisites
- Ensure your system meets the minimum requirements for Amahi before proceeding.
- Download the Fedora 19 DVD (the full DVD, netinstall may work, LiveCD may work, but only minimal is supported) for your architecture (32 bits or 64 bits, these apply to both)
- HTTP (Report if links broken):
- Torrent (request users seed after download):
Install Fedora
- Install Fedora 19 minimal (NOT the Desktop):
- Boot, choose Install Fedora, choose language; then in software selection choose minimal install
- This is NOT the default and is at the bottom of the list. Don't forget to remove the DVD after installing and before rebooting.
- Choose the hard drive partitioning scheme
- DON'T change the hostname (it may create issues)
- Click on Begin Installation and the installer will proceed
- Create a user with a password. Make sure it's an admin user. Recommend creating a root password.
- After a minimal install one needs to login as root first (in a text console)
- Login with the user and become root for the rest of the installation
sudo su -
Install Amahi
- Install the Amahi repo by hand with:
rpm -Uvh http://f19.amahi.org/noarch/hda-release-6.9.0-1.noarch.rpm
- Get the mariadb base packages (this is to avoid dependency conflicts)
yum -y install mariadb-libs mariadb-server
- Try installing both hda-ctl and hda-platform. This should install a lot of dependencies with them
yum -y install hda-ctl hda-platform
- If that works, ```and only if that works```, so the Amahi install (also as root; replace YOUR-INSTALL-CODE with the code you set up in Amahi.org):
hda-install YOUR-INSTALL-CODE
- If that fails, check the Express Disc troubleshooting page. For help, please fpaste the log (you may have to yum -y install fpaste). The log should be in
/root/hda-install-*.log
- If all goes well, it should tell you to reboot
Post Install Notes
- It will boot with the static IP you preconfigured in the Amahi control panel
- You can verify if the dashboard is available by accessing from any client using the IP address.
- It's strongly recommended that you turn off the previous DHCP server and let Amahi handle DHCP so that DNS falls into place
- Reboot all the clients to get them to use your Amahi server
- Your Amahi dashboard should be available at http://hda
- The first time it will initialize and will ask you to login to create a dashboard password for the admin user you created
