Difference between revisions of "Network customizations"
From Amahi Wiki
| Line 14: | Line 14: | ||
* DYN_LO: low end of the dynamically allocated DHCP range (defaults to 100) | * DYN_LO: low end of the dynamically allocated DHCP range (defaults to 100) | ||
* DYN_HI: high end of the dynamically allocated DHCP range (defaults to 254) | * DYN_HI: high end of the dynamically allocated DHCP range (defaults to 254) | ||
| + | |||
| + | After you change a setting, you must | ||
| + | |||
| + | service hdactl stop | ||
| + | service hdactl start | ||
| + | |||
| + | for the setting to be picked up. | ||
Revision as of 18:42, 21 July 2012
|
WARNING |
|---|---|
| This should only be attempted by advanced users. It also needs more proper documentation. |
Amahi has a daemon that helps configure the network settings. It's called hdactl.
This network daemon can de customized by advanced users. Configuring things improperly can yield an invalid configuration and a broken DNS, DHCP or network subsystem.
The followind settings can be set in customized in /etc/hdactl.conf
- DEVICE: set it to eth1 to make services attach to eth1 (default: eth0)
- NETMASK_SIZE: number of bits in the netmask (default: 24 ... i.e. 255.255.255.0)
- NET_START: what's the start of your network, passed into the acl trusted group (defaults to 0)
- DYN_LO: low end of the dynamically allocated DHCP range (defaults to 100)
- DYN_HI: high end of the dynamically allocated DHCP range (defaults to 254)
After you change a setting, you must
service hdactl stop service hdactl start
for the setting to be picked up.
