Enabling WOL

From Amahi Wiki
Revision as of 20:32, 18 January 2011 by Jayrock (talk | contribs)
Jump to: navigation, search

To enable Wake-On-Lan (WOL) on your hda:

1. Enable WOL in the BIOS

2. Boot Fedora. Open a terminal and execute su to get root access

3. Assuming your LAN interface is on eth0, run ethtool eth0

The output will look similar to this:

[root@localhost ~]# ethtool eth0
Settings for eth0:
Supported ports: [ TP MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Advertised auto-negotiation: Yes
Speed: 1000Mb/s
Duplex: Full
Port: MII
PHYAD: 0
Transceiver: internal
Auto-negotiation: on
Supports Wake-on: pumbg
Wake-on: g
Current message level: 0x00000033 (51)
Link detected: yes

4. Look for a line similar to this:

Wake-on: g This means that WOL by magic packets is enabled on that interface.

If the line is Wake-on: d then WOL is disabled. Activate it by running ethtool -s eth1 wol g

If you don't find any line containing Wake-on at all, then your interface card doesn't support WOL, or the OS cannot detect it.

Check the ethtool man pages for a full explanation of the Wake-on options

  • Note: Some legacy drivers forget the setting during boot. Run ethtool eth0 again if you suspect this is the case