Amahi 11 Upgrade
Warning! |
---|
The Amahi team strongly recommends installing from scratch over the upgrade.
|
- NOTE:
- For Amahi 7 users, an Amahi 10 Upgrade will be needed before the Amahi 11 upgrade can be accomplished (be advised this is untested).
Upgrading Amahi 10 to Amahi 11
Preparation
We recommend you turn on a temporary DHCP server, (e.g. in your router) since the network may go down for the duration of the actual upgrade.
Execute all commands as root
user or precede commands with sudo
- Upgrade will work best if apps are uninstalled
- Back up your data as a precaution
Let's begin!
- Update everything in the system:
dnf -y update
- Reboot to pick up new kernels, etc:
shutdown -r now
- Update everything in the system again:
dnf -y update
- If there are any updates, do it again. If there are new kernels, reboot:
shutdown -r now
Execution
Install the upgrade tool:
dnf -y install fedup
Do the live update over the network:
fedup -y --network 27 --nogpgcheck --allowerasing
Once the previous fedup command is complete, you will be prompted to run:
dnf system-upgrade reboot
The actual upgrade will take place now, so you will not be able to access the server (or possibly the network) until it is complete.
It would be good to have a monitor/keyboard on the system to cover the risk that the upgrade process becomes stuck somehow. This also should let you keep up with progress.
Be aware it may take 15 to 30 minutes at a minimum for the upgrade to complete, depending on your hardware. It may take *much longer* on a slower network or hardware.
Finalize
Once the upgrade is complete, execute the following to disable the firewall:
systemctl stop firewalld systemctl disable firewalld systemctl stop rolekit systemctl disable rolekit
You now should be able to access the dashboard at http://hda.
Troubleshooting
Visit the troubleshooting page if you find yourself in trouble.
Go back to Amahi Docs page.